Instructions

1. Place the quick-change adaptor in the assembly support.
2. Insert the ER collet in the nut screw.
3. Partially tighten the nut screw on the quick-change adaptor.
4. Insert the tap in the quick-change adaptor until it stops.
5. Lightly tighten the nut screw to clamp the tap shank.
6. Tighten the setting screws on the tap square*.
7. Securely tighten the nut screw with a wrench.
8. Check that setting screws are not too tight.
9. Insert the quick-change adaptor into the tapping attachment by pulling back the sleeve.

(*) The setting screws are not necessary when using collets with square drive.